MCN-034 5-1/4”Jamb

Dimensions

• Overall Depth / Jamb Width: 5.25″ (133.35 mm)
• Depth to Door / Backbend: 1.25″ (31.75 mm)
• Main Body Thickness: 0.75″ (19.05 mm)
• Effective Installation Depth: 3.124″ (79.35 mm)

Note: Key profile dimensions shown above. The 5-1/4″ jamb depth falls between the standard 4-9/16″ and extended 6-9/16″ sizes, suitable for medium-thickness walls.

Key Features

• 5-1/4″ Moderate Depth – Between Standard Depth and Extended Depth fixtures, can accommodate varied wall thicknesses.
• The precision mounting dimensions for all Niblotype models are listed below to facilitate easy selection of the correct model. Each model can be readily installed on site.
• Sturdy support for the door.
• Very decorative – Fits completely from the frame to the wall surface. A uniform design look.
• Easy installation – Can be nailed, adhered, or screw-mounted
• Standard with paintable surface. Can be painted together with the door leaf and wall surfaces for an uniform colour finish.

Applications

• Interior and exterior door frames for medium-thickness walls
• Creation of door opening finishing for houses, apartments and commercial buildings.
• Replacement of old jambs in renovation projects
• details for timber frames that require a depth that is greater than the deepest standard and deeper than the deepest extended component depth.
• Door jamb installation for various building entrances

Installation Tips

• It would be well to check the actual wall thickness before putting the item in to make sure the 5-1/4″ dimension is adequate.
• Place the Jamb into the opening and make certain that the Jamb is plumb and square.
• Secure with appropriately sized screws or nails into the wall structural layer.
• Put some expandable foam in the gaps between the jamb and the wall where it’s needed.
• Apply paint or veneer to the substrate as required to match either interior or exterior finishing techniques.